To install the Aqua between my spigot and hose, I threaded the device directly onto each. If you are using drip tubing instead of a hose, you’ll use the included adapter to connect an irrigation line to the Aqua. While the directions are relatively simple, I had an issue getting a great seal on the spigot side of the Aqua, even with pliers. The location of the handle made it impossible to squeeze a tool in to tighten up the connection, which meant that, ultimately, I was never able to avoid some level of water leakage from this area. (An Eve representative suggested using plumber’s tape to improve the seal or adding an angled adapter or hose extension to the setup to make the angle less awkward, but I didn’t test either method.) It is however easier to get a good seal on the lower connection that attaches to the hose, as there’s not as much hardware to get in the way on the underside of the Aqua. Testing the Hardware and Software ScreenshotEve app …